Dee Zee DZ370641 User Manual
Page 3

SIDE BARS
2007 - 13 JEEP WRANGLER 2 DOOR
Page 2 of 3 03/19/12 Rev2 (DP
)
5. Carefully unwrap and position the driver Sidebar onto the Brackets. Attach the Sidebar to the Mounting
Brackets using the included (4) 8mm x 25mm Hex Bolts, (4) 8mm Lock Washers and (4) 8mm Flat
Washers (Figure 4). Do not tighten at this time. NOTE: The Sidebar has (2) sets of inserts to bolt the
Sidebar to the rear Bracket.
a. 2007: Use the rear set of inserts closest to the rear tire, (Figure 7).
b. 2008 - 12: Use the forward set of inserts, (Figure 8).
6. Level and adjust the Side Bar and Brackets and tighten all hardware.
7. Repeat Steps 2 - 6 for Passenger Sidebar installation.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver Side Installation Pictured
(Fig 1) 2007-10 driver side front mounting location
(Fig 2B) Nut Plate
(1)10mm x 35mm Hex Bolt
(1)10mm Flat Washer
(1)10mm Lock Washer
6mm x 25mm Allen Bolt,
6mm x 18mm Small Flat Washer (outer)
6mm ID x 23mm Large Flat Washer (inner)
6mm Nylon Lock Nut
Fig 2A
(Fig 3) 2011-12 threaded hole-Nut Plate not required
Fig 4
Front
Front
Front
Front
8mm x 25mm Hex Bolts
8mm Flat washers
8mm Lock Washers
Vehicles with threaded
hole in body panel use:
8mm x 35mm Hex Bolt
8mm Large Flat washer
8mm Lock Washer