Monoprice 5919 Wall Mount Bracket - Manual (Page 4)

4 of 8
A
‡ Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and
components.
WARNING
‡ Tighten screws so that double stud wall plate is firmly attached, but do not overtighten. Overtightening can damage
the screws,greatly reducing their holding power.
‡ Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder
is highly recommended.
WARNING
Wall arm assembly (AA) must be mounted onto two wooden studs,with center to center distances more than
12". Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an
edge to edge stud finder is highly recommended. Use a level to draw two vertical lines down the center of the stud.
Use wall arm assembly(AA) as template to mark center of holes along the vertical line.Make sure the correct
direction about installation of the wall arm assembly. Drill six 6mm(1/4") dia. holes 3.3"deep.Attach wall arm
assembly (
AA) to wall using six hex head screws (N)and six washers (C) as shown in fig. A.1
Installation to Wood Stud Wall
fig.A.1
wo
od
stu
d wal
l
N
AA
C