Audiovox P-88 - Manual (Page 3)

-2-
3
SELECT BUTTON (SEL)
DISPLAY CALL
DISPLAY PRIORITY SELECTOR
IGNITION-OFF CLOCK CALL (CLK)
This button is used to select the audio function (volume, bass,
treble, balance, or fade) to be adjusted using the Level Control
2
,
as well as the indication (time, frequency, or CD) shown on the
display panel.
During radio operation, a momentary press of the button will
change the display from frequency to clock time. Another press
of the button will change to station pre-set number (if the selected
frequency is one of the 6 pre-set stations on the band in use). After
5 seconds, the display will automatically return to frequency if set
to frequency/CD display priority. If the unit has been set to time
display priority, momentary presses of th e button will change the
display from time to frequency/CD track number and then pre-set
number/CD elapsed time. After 5 seconds, it will change back to
time display.
During CD operation, a momentary press of the button will change
the display from track number to clock time. Another press of the
button will change to CD elapsed time. After 5 seconds, the display
will automatically return to track number if set to CD track display
priority. If the unit has been set to time display priority, momentary
presses of the button will change the display to CD track number
and then CD elapsed time. After 5 seconds, it will change back to
time display. If the unit has been set to elapsed time priority,
momentary presses of the button will change the display to clock
time and then CD track number.
Additional momentary presses of the button will set the unit for
bass adjustment (level number above “BASS” will flash on display
panel), treble (level number above “TREBLE” will flash), balance
(“bAL” on display), fader (“FAd”) or volume (level number). The
display will automatically return to the normal indication 5 seconds
after the last adjustment is made or when another function is
activated.
This unit can be set so that either the clock time or radio frequency/
CD function will normally appear on the display panel. Use the
following procedure to set the display priority:
CLOCK TIME PRIORITY: With radio frequency on the display
panel, press and hold the Select button for approximately 2
seconds until clock time is shown.
The display will now
automatically return to time display 5 seconds after any other radio,
CD or audio function display.
NOTE: Release the button as soon as the display changes from
frequency to time (approximately 2 seconds). Holding the
button in for too long will put the unit into time setting mode
(flashing time display). See section on “Setting the Clock”.
FREQUENCY/CD TRACK PRIORITY: With clock time showing on
the display panel, press and hold the Select button for
approximately 2 seconds until the frequency display is shown. The
display will now automatically return to radio frequency or CD track
5 seconds after any other function is activated.
CD ELAPSED TIME PRIORITY: During CD play mode, press and
hold the Select button for approximately 2 seconds until the
elapsed time display is shown. The display will now automatically
return to elapsed time 5 seconds after any other function is
activated.