Anthem MRX 710 - Manual (Page 50)

41
5.6 BASS / TREBLE / BALANCE
To change tone, press Bass or Treble on the remote control then up/down. Note that Bass
does not affect the subwoofer output – this is handled by the Level adjustment.
To change balance press BAL on the remote then up to move the image to the right, or
down to move the image to the left.
5.7 LIP-SYNC
If the audio is not synchronized with the video, press Lip-Sync then up/down. Up to 150
milliseconds of audio delay may be used. Changing lip-sync on the fly changes the input’s
lip-sync setting in the setup menu.
5.8 LISTENING MODES
Refer to the Input Setup section for a description of listening modes. Once the receiver’s
display shows the input format, the listening mode preset will apply. If you wish, you can
make a different selection after pressing the MODE button.
When playing a multichannel source, a listening mode may not be applicable if the source
material is not PCM and its sampling rate higher than 96 kHz, or if you are using less than
7.1 speakers and the source is already multichannel.
At times it might appear that the receiver is detecting a sound format different from
the one that you would like to be playing. Note that the source is in control and that
the connection to the receiver carries one format at a time. To ensure that audio is
sent to the receiver in its original form:
1. In the source’s setup menu ensure that digital audio output is set to Bitstream
mode for all Dolby Digital and DTS formats.
2. If the source is a Blu-ray player, also ensure that Secondary Audio is disabled.
3. If the source material is on Blu-ray or DVD, you may want to select an audio track
other than the disc’s default. There are two ways to do this – through the audio or
language setup in the disc’s menu, or during the movie by pressing AUDIO on the
player’s remote control.
BASS
TREB
BAL
LIP-SYNC