Tuff Country 56901 - Toyota Tacoma 05-14 performance 6 lift kit - Manual (Page 16)

61. Working on the passenger side differential bracket, add
some thread locker or loctite and torque the (2) stock bolts
that connect the bracket to the differential to 75 ft lbs. Add
some thread locker or loctite and torque the (2) new 1/2”
bolts and hardware that connect the bracket to the front and
rear cross members to 68 ft lbs.
62. Add some thread locker or loctite and torque the stock
allen headed nut on the driver side rear portion of the differ-
ential to 54 ft lbs.
63. Going back to the driver side steering knuckle add some
thread locker or loctite and torque the (2) stock lower bolts to
95 ft lbs. Torque the castle nut on the upper ball joint to 68
ft lbs. Now install the stock cotter pin. Special note: If you
are not able to install the stock cotter pin because the
hole in the upper ball joint does not line up with the cas-
tle nut, DO NOT loosen, tighten the castle nut until the
stock cotter pin can be installed. Repeat on passenger
side
64. Locate the stock brake rotors. Working on the driver side,
install the rotors into the stock location. Special note: For
now, thread on 2 lug nuts by hand to hold the rotor in
place while you
install the brake
caliper.
Repeat
procedure on the
passenger side.