Tuff Country 56901 - Toyota Tacoma 05-14 performance 6 lift kit - Manual (Page 12)

42. Working on the driver side, remove the (2) stock bolts
that are holding the sway bar to the frame rail. Repeat on
passenger side and remove sway bar from vehicle. The
stock hardware may be discarded.
43. Locate the (2) new sway bar relocation brackets. Also
locate (4) 8 mm x 30 mm socket head screws, (4) 5/16” USS
flat washers and (4) 3/8” unitorque nuts from hardware bag
56900NB bag # 1.
44. Working on the driver side, be sure to apply some thread
locker or loctite to the threads of the new 8 mm x 30 mm
bolts, now install the new sway bar relocation bracket mak-
ing sure that it is installed so that it moves the sway bar
towards the front of the vehicle. Repeat on passenger side.
Once the new
bolts are started,
make sure to
torque the 8 mm
bolts to 12 ft lbs.
45. Locate the stock sway bar. Install the sway bar onto the
new brackets using the new 5/16” USS flat washers and 3/8”
unitorque nuts. Do not tighten at this point.
46. Locate the new coil overs. Working on the driver side,
install the new coil over into the upper stock location using
the stock bolts that are supplied in the new coil overs upper
plate. Make sure to use thread locker or loctite and torque to
38 ft lbs.