Tivax HiRez 7 Portable TV User Manual - Manual (Page 30)

Tivax HiRez7 Portable TV
29
There are two ways to switch to a desired channel directly. For example: if you
want to switch and watch CH25-1:
Method 1 (by using the Remote Control Unit):
Press the numeric keys on the RCU and than press OK key to switch.
Method 2 (by using the U/D, L/R & OK buttons):
1. While Menu mode is not activated, press OK button on your TV to enter
the “CH number setting” menu.
2. Press U/D (e.g., CH+/-) button to select the CH number (go up or down).
Keep holding down U/D key for fast increasing or decreasing the channel
number until it reaches the channel desired. Press the R (Vol +) button to
move the cursor position Cursor at the selected position becomes flashing.
Antenna: Major CH number: 2 to 69.
Cable: Major CH number: 1 to 135.
Minor CH number: 1:9993
3. After the CH number 25-1 has been set, press the OK key again to switch
to channel.
Note: Before inputting the channel number, make sure the source type is
set as Antenna. Please refer to chapter 1.2.1 on how to change the source
type.
1.7 Signal Level Menu
1. Signal key: calls “ Signal Level ” menu.
2. It will also automatically be shown when the channel is changed.
Color bar menu：
Red: signal is weak.
Yellow: signal is good.
Green: signal is strong