Spyder Auto PRO-YD-BMWE38 99-01 HID TYPE 7 Series - Manual (Page 2)

Remove the facotry headlight from the BMW. First
remove the front panel cover below the headlight to
access the bottom screw of the headlight housing.
There is also two screws on the top of the housing.
Once you have remove the headlight, turn the
headlight around and remove the bracket that holds
the Ballast. Then remove the ballast using a philip
screwdriver.
Unplug the wire from the ballast, and then remove
the Xenon Plug from the housing. Put the Ballast
aside.
Carefully remove the D2S Xenon Bulb from
the factory housing. Once you have remove the
bulb, transfer the bulb to the Spyder headlights.
Remove the bracket from the Spyder Headlight,
and then install the ballast on the housing like
the original. Once you have put the ballast on,
put the bracket back on.
Remove the Panel Cover bracket from the origi-
nal headlight to the new Spyder Headlights as
shown here.
STEP: