Sper Scientific 800106 Infrared IR Thermometer Gun 12:1 - Manual (Page 12)

High Alarm (HAL)
1. Pull the Trigger (3) ,then press the Function(24)bu-
tton until HAL(14) appears on the display.
2. Use the up( 23) or down(16) buttons to set the high
alarm value.
3. The Thermometer will beep when the temperature
reading is higher than the alarm setting.
4. When the adjustments are complete, the thermometer
will return to the SCAN(17) mode after approximately
six seconds.
Low Alarm (LAL)
1. Pull the Trigger (3) ,then press the Function(24)bu-
tton until LAL (14) appears on the display.
2. Use the up ( 23) or down (16) buttons to set the low
alarm value.
3. The Thermometer will beep when the temperature
reading is lower than the alarm setting.
4. When the adjustments are complete, the thermometer
will return to the SCAN(17) mode after approximately
six seconds.
10