Sper Scientific 850013 Advanced Datalogging Sound Meter - Manual (Page 17)

17
MEASUREMENT PROCEDURES
stored in the memory, “FULL” appears on the LCD.
Clearing Auto-Stored Data
1. Press and hold POWER to turn the meter off.
2. Press and hold REC. While still holding REC, press and
release POWER. “CLr” appears on the LCD. The LCD
displays “SURE 5, 4, 3, 2, 1, 0.” (The meter allows 5 se-
conds to abort the operation by releasing REC.) Con-
tinue holding REC until the meter returns to Normal
Mode. The memory is now cleared.
Manually Storing Data
1. Press MEM to store up to 99 data point using manual
storage.
Reading Manually-Stored Data
1. Press RECALL. “READ” appears on the LCD.
2. Press or to select the data set. The data will
display on the LCD. If there are no data in a data set,
“MEM00” appears on the LCD. Press RECALL to exit
Recall Mode.
Clearing Manually-Stored Data
Press and hold RECALL. While still holding RECALL,
press and release POWER. “CLr” appears on the LCD.
The LCD displays “SURE 5, 4, 3, 2, 1, 0.” (The meter allows
5 seconds to abort the operation by releasing RECALL.)
Continue holding RECALL until the meter returns to Normal
Mode. The memory is now cleared.