Sper Scientific 850023 Anemometer SD Card Logger User Manual

Page 20

DATALOGGER

Note

To enable/disable the touch-tone feature, see page 13.

Manual Datalogging

1. Set the sampling time to 0 seconds. Refer to page 14.

2. Press REC. “REC will appear on the LCD.

3. Press LOGGER. “REC” will flash on the LCD and the

alarm will sound while the measurement data and time
information are saved to memory. The position
(location) number will appear on the bottom of the LCD
and will also be recorded on the SD card.

Note

To enable/disable the touch-tone feature, see page 13. To
change the position number, press ▼. The position
number will flash on the LCD. Press ▲ or ▼ to set the
position number (from 1 to 99). To indicate the position
location, P x (x = 1 to 99) will appear on the lower display.
After selecting the position number, press ENTER to
confirm.

4. To finish datalogging, press REC for longer than 2

seconds. “REC” will disappear from the LCD to indicate
that datalogging has ended.

SD Card Data Structure

1. The first time a SD card is used in this meter, a folder

AMA01 will be generated.