Speedtech Clutch Master Bracket - Manual (Page 3)

3 | P a g e
Once the factory rod end is removed, slide the ATS supplied pushrod end onto
the shaft until it bottoms out. Crimp and/or TIG weld the assembly together.
2. Unbolt and carefully move your brake master cylinder and power booster away
from the firewall. Depending on the application, removing brake lines may not be
necessary. However, you must keep the assembly supported and be careful not
to kink or excessively bend any brake lines. Slip the Clutch Master Bracket over
the original mounting studs. Bolt the clutch master cylinder to the bracket using
the supplied 5/16” bolts. Now reinstall your brake booster/ master cylinder.