SIGMA ROX 5.0 - Manual (Page 11)

Page 11
Initial use
attaching the roX 5.0 and initial use roX 5.0
www.sigmasport.com roX 5.0
2.7 initial use
to conserve energy, the roX 5.0 comes in ‘deep sleep mode’. simultaneously
press and hold the Mode 1 + set buttons for five seconds to awaken the
roX 5.0 from deep sleep mode.
the roX 5.0 jumps to setting mode.
2.8 Synchronizing the sensors
to synchronize the sensors, the roX 5.0 must be clicked into the bracket.
the zeros of the speed, cadence, and heart rate values flash while the respective
sensors are being synchronized.
once synchronization is complete, the respective values appear on the roX 5.0’s
display.
2.8.1 Synchronizing the speed
there are two options for synchronizing the speed:
− start cycling – the receiver usually synchronizes with the sensor after five
wheel rotations.
− spin the front wheel until the km/h information appears on the display.
2.8.2 Synchronizing the cadence
there are two options for synchronizing the cadence:
− start cycling – the receiver usually synchronizes with the transmitter after
five pedal rotations.
− turn the pedals until the current cadence appears on the display.
2.8.3 Synchronizing the chest belt
Moisten the sensor areas on the chest belt and put it on.
Move into the vicinity of the roX 5.0 or get onto your bike. the roX 5.0 usually
synchronizes with the chest belt in less than 10 seconds.
the current heart rate then appears on the display.