Rubbermaid 9VULPB12 - Manual (Page 8)

14 15
5
Loop belt around motor shaft. Slide belt onto pulley.
Align tabs on nozzle guard and pivot into position, making
sure nozzle guard tab snaps into place.
Orient brush roll endcaps. Align endcaps with slots in nozzle
base while pulling brush roll towards the nozzle opening.
Reinsert into slots.
6
Reinstall screws.
1
2
2
7
2
1
3
8
9
Tool needed 1 2
Remove screws. Remove old edge-cleaning bristles. Unplug before servicing.
3
Install new edge-cleaning bristles. Reinstall screws.
Edge Cleaning Bristles Replacement
ENGLISH
Belt and Brush Roll Replacement
(cont.)