Powerwinch Deck Mate 25 User Manual
Page 7
Operating Instructions and Replacement Parts List
Deckmate 25 Free Fall Pontoon Windlass
7
Installing The Switch On The Helm
1. Find a suitable location to install switch. Make sure
there is enough room behind the switch mounting loca-
tion for the switch and wiring to the switch.
2. Cut a rectangular hole that is 1 7/8” wide by 1 5/8”
high. Refer to Figure 11.
Step 4. Installing the switch and wiring the winch to the
battery. (continued).
11 77//88""
11 55//88""
Figure 11. Size Of Switch Mounting Hole
3. Locate rocker switch in parts pack and assemble
into switch plate as shown in Figure 12.
Figure 12. Switch Plate Assembly
Rocker Switch
Switch Plate
Rear view of switch.
Make sure angled
terminals are located
as shown.
Top of Switch
Plate
4. Locate push button switch for light and rubber
boot that fi ts over switch and assemble as shown in
Figure 13.
Step 4. Installing the switch and wiring the winch to the
battery. (continued).
Switch Boot
Push Button
Switch
Figure 13. Light Switch Assembly.
Insert push button switch through hole in switch
plate and secure with switch boot.
5. Locate the switch cover plate in the parts pack
and the four screws needed to secure the plate to the
winch cover. Assemble the switch cover plate as
shown in Figure 14.
Figure 14. Switch Cover Plate Assembly
Switch Cover Screw
(Qty of 4)
Switch Cover Plate
(Qty of 4)