Apple Xserve (Drive Interconnect Board Replacement) - Manual (Page 9)

Xserve Drive Interconnect Board - 9
Installing the Replacement Drive Interconnect Board
1. Install the replacement drive interconnect board on the two mounting pegs in the
chassis. (Figure 10)
2. Check that the board engages with the three brackets on the chassis.
3. Press the board firmly toward the front of the server, and tighten the three
thumbscrews that secure the board to the chassis.
Figure 10
4. Connect the following cables to the drive interconnect board: (Figure 11)
• optical drive cable
• power supply cable
• locking switch cable
• front panel board cable
• FireWire cable
Figure 11