MBRP S5406 - Manual (Page 2)

S5406 © 03/13 PAGE 2 OF 4
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Remove nuts from the exhaust flanges behind the catalytic converters.
Refer to Figure 1 and 2.
3. Remove existing exhaust hanger by removing the two bolts on the
hanger. Keep for reinstallation. Refer to Figure 3.
4. Lubricate then remove hardware from the rearmost exhaust hanger.
Keep for reinstallation. Refer to Figure 4.
5. Loosen slip joint behind muffler. Remove the hanger from the rubber
insulator. Remove the exhaust from the vehicle. Refer to Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4