MBRP S5302 User Manual
Page 4
S5302 © 03/13
PAGE 4 OF 4
7. Slide a 2.5” Clamp over the outlet of the passenger side Muffler.
Position the Passenger Side Over Axle Pipe over the axle and loosely
attach it to the Muffler. Loosely attach to the Driver Side Over Axle
Pipe using hardware provided. Refer to Figure 10.
Note, additional 5/16” Flat Washers are provided in case spacing is
required for adjustments.
8. Slide the Passenger Side Tail Pipe onto the Passenger Side Over
Axle Pipe installing the hanger to the existing rubber insulator. Refer to
Figure 11.
9. Install and adjust the Exhaust Tips to suit. Using a 17mm wrench
tighten the lock bolt located on each Exhaust Tip.
10. Align the exhaust as required. Starting at the front of the vehicle
exhaust, tighten all clamps and connections.
12. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines.
Congratulations! You are ready to begin experiencing the improved power, sound and driving experience of your
MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
Figure 10
Figure 11