MBRP S5048 User Manual
Page 4
S5048 © 03/13
PAGE 4 OF 4
7. Slide a 2 ½” Clamp onto the Cross Pipe and then attach the Driver Side
Tail Pipe hanger into the Hanger Assembly and to the Cross Pipe. Refer to
Figure 10.
8. Install and adjust the Exhaust Tips to suit. Using a 17mm wrench tighten
the lock bolt located on each Exhaust Tip.
Refer to Figure 11.
9. Align the exhaust as required. Starting at the front of the exhaust, tighten
all clamps and connections.
10. Check along the whole length of the exhaust system to ensure that there
is adequate clearance around the spare tire, fuel and brake lines or any
wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving experience of
your MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 10
Figure 11