MBRP S5048 - Manual (Page 3)

S5048 © 03/13 PAGE 3 OF 4
2. Slide a 2 ½” Clamp over the Extension Pipe and install the Muffler
onto the Extension Pipe. Attach the Muffler to the existing rubber
insulators. Refer to Figure 5.
3. Slide two 2 ½” Clamps over the outlets of the Muffler. Position the
Passenger Side Tail Pipe and loosely attach it to the Muffler Assembly.
Install the Passenger Side Tail Pipe hanger into the existing rubber
insulator. Refer to Figure 6.
4. Loosely install the Over Axle Pipe to the Muffler Assembly.
Refer to Figure 7.
5. Slide a 2 ½” Clamp over the Over Axle Pipe then loosely attach the
Cross Pipe to the Over Axle Pipe. Refer to Figure 8.
6. Install the Hanger Assembly using the fasteners provided.
Refer to Figure 9.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9