MBRP CFGX013 User Manual
Page 2
FGX012/CFGX013 © 09/13
PAGE 2 OF 4
2013-14 Ford Focus ST
Removal of Stock Down Pipe:
1. Remove the engine cover and the air intake pipe to access the oxygen
sensor connectors.
Refer to Figures 1 and 2.
2. Carefully disconnect the oxygen sensor connectors. The front sensor
connector is attached to a bracket bolted to the cylinder block. Note the
routing of the wires and the two small plastic wire guides that clip on the
factory steel lines. Access is indicated by the arrow in Figure 2.
Refer to Figure 2.
3. Lower the rear of the under car engine cover.
Refer to Figure 3.
4. Remove the two nuts from the front resonator assembly.
Refer to Figure 4.
5. Remove the cross member that sits just below the down pipe outlet.
Refer to Figure 4 (Arrow).
6. Remove the catalytic converter support bracket. Retain the bracket, the
mesh isolator and the hardware for installation.
Refer to Figure 5.
7. Loosen the V-band clamp on the turbocharger outlet enough to
release it.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5