ADC Gas Electric Steam WDA-540 - Manual (Page 52)

50
S. PROGRAM LOCATION 16 (PL16) AND PROGRAM LOCATION 17 (PL17)
Maximum Active Anti-Wrinkle Time
Location to be viewed/changed.
Press “Perm Press” key. Display
will read “AGt,” maximum guard
time for 3-seconds and then time
programmed. If no change, press
“Perm Press” key, otherwise press
“HI” or “LO” keys and then “Perm
Press” key.
Location to be viewed/changed.
Press “Perm Press” key. Display
will read “A,” and factor programmed
for 3-seconds. If no change, press
“Perm Press” key, otherwise press
“HI” or “LO” keys and then “Perm
Press” key.
Display will read “B,” and factor
programmed for 3-seconds. If no
change, press “Perm Press” key,
otherwise press “HI” or “LO” keys
and then “Perm Press” key.
PL16
AGt
Perm Press
10 HI Temp
Perm Press
LO Temp
Refer to Section V for instructions
on entering program locations.
(Wait 3-Seconds)
A 6
("Hold In" to Accelerate) ("Hold In" to Accelerate)
LO Temp
Perm Press
B 65
Proceed to next location
to be changed
To exit program mode,
open program switch
("Hold In" to Accelerate) ("Hold In" to Accelerate)
PL17
Refer to Section V for instructions
on entering program locations.
Perm Press
A 6
(Wait 3-Seconds)
B 65
Perm Press
70F
LO Temp HI Temp
HI Temp
("Hold In" to Accelerate) ("Hold In" to Accelerate)
Time Decrease Time Increase
Factor Increase
Factor Increase Factor Decrease
Programmable 1 to 9
Programmable 1 to 99
Factor Decrease