MBRP S6000 - Manual (Page 4)

10. Install provided clamps around pipes where needed. Adjust tail pipes and check along the whole length
of the exhaust system to ensure that there is adequate clearance around the spare tire, fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
11. Make sure the exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
12. Install and adjust Tip to suit. Using a 17mm wrench tighten lock bolt located on Tip.
“PRO SERIES” exhaust shown.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
S6000 © 03/09 Page 4 of 4