7 error codes (status light blink sequences) – Innovate Motorsports PL-1 User Manual
Page 7

- 7 -
6.3
Erasing the Log from the memory card
1. Remove the memory card from the PL-1’s SD memory card slot.
2. Connect the SD card reader to a USB port on your Windows machine.
3. Insert the memory card into the SD card reader.
4. Windows will usually pop up a windows with the contents of the memory card, if this
does not happen you can go directly to the drive under “My Computer.”
5. In the memory card you will find a file named “Log.d32”. Select this file and click the
delete button on your keyboard. If prompted, confirm that you want to delete the file.
7 Error Codes (Status light blink sequences)
Blink
Sequenc
e
Error Code
Solution
2
SD Card - File system
initiation and function failed.
Card not formatted
Memory card failure
Memory card incompatible
3
SD Card - Write Protect is
switched ON
Move the write protect switch to the OFF
position
4
MTS Data Error - MTS serial
communication error.
Power OFF all MTS devices and verify that
all serial connections are fully seated.
Connect MTS devices individually to
LogWorks software and verify serial
communication.
5
MTS Data Error – Iinitialization
error
Verify that total number of channels on the
MTS serial chain does not surpass 32.
6
SD Card – Write Error
Card not formatted
Memory card full
Memory card failure
7
MTS Data Error
Memory card failure
Verify number of channels is no more 32
8
SD Card – could not open log
file for writing
Card not formatted
Memory card failure
9
Missing or Corrupt Firmware
Contact Innovate Motorsports Support