Hootoo HT-IP006N - Manual (Page 5)

Security Solutions Partner
5
default settings. (Please keep the power on when using RESET)
Power: DC 12V/2A power supply
1.4 PC System Requirements
System configuration requirements: (Example for viewing four IPCAM)
CPU: 2.06GHZ or above
Memory: 256M or above
Network Card: 10M or above
Display Card: 64M or above memory
Recommendable Operating System: Windows 2000/ XP/ Vista/ 7
1.5 Hardware Instruction
Follow the steps below to set up your camera hardware. Make sure to follow each step carefully to ensure that
the camera operates properly.
1. Install the Wi-Fi antenna
2. Plug the power adaptor into the camera
3. Plug the network cable into the camera and router/switch
4. It takes approx. 30 seconds to boot up the camera, then you will find the IP address from
“IP Camera Tool” (Figure: 1.8)
5. When the power is on and network cable connected, the green LED of the panel will stay on,
The yellow LED will keep flashing.
Figure1.3
1.6 Software Installation
Attention: For a smoother installation process, we suggest that turn OFF your Firewall and Antivirus before
install the ActiveX, Don’t worry, it is safe.
Install the following software:
1. IP Camera Tool: Open the CD, double click “IPCamSetup.exe”, click next, you will complete the software
installation.(figure1.5/ 1.6/ 1.7)
2. ActiveX: Double click “Appinstall.exe”—“Next”—“Install”—“Finish”.
Figure1.4