Eddie Motorsports MS107-60 - Manual (Page 9)

9
3. Install tensioner cover using two 10-32 x ¾ flat head screws with thread locker.
Install Compressor Manifold: Do not perform this step until you are ready to install
AC lines and charge your system!
1. Remove the plate on the top of compressor body. The compressor is Nitrogen charged to insure
lubrication of all components during transport. You will hear the gas escaping when you loosen the
fasteners.
2. Install manifold as shown using two M8 x 25mm cap screws with anti seize.
WARNING: Do not connect power to the AC clutch wire without first connecting hoses and charging the
system. Please follow all of the enclosed instructions for charging your system. Serious damage to your
compressor can occur and the warranty will be voided.
EDDIE MOTORSPORTS IS NOT RESPONSIBLE FOR CUSTOMER APPLICATIONS THAT ARE
OUTSIDE THE NORMAL INTENDED USE OF OUR PRODUCTS, INCLUDING SPECIFIC MODEL
AND YEAR APPLICATIONS, ENGINES EQUIPPED WITH SUPER CHARGERS, AND LATE
MODEL EMISSIONS EQUIPPED VEHICLES.
PLEASE CALL WITH ANY QUESTIONS: 888-813-1293