Avanti PARTY PUB CB350S - Manual (Page 13)

13
OPERATING YOUR PARTY PUB
 Setting the Temperature
You will need to set the temperature to best suit your taste.
The temperature can be set from 38º to 43ºF (3° to 6°C), using the temperature selectors (
and )
located below the temperature display.
 Interior LED Light
The Party Pub is also equipped with an interior LED light, that can be turned ON or OFF by pressing
the light ON / OFF button.
Dispensing Your Beer
• Always use clean glasses rinsed with very cold water at the time of serving. Impurities prevent the
foam from forming in the glass.
• Hold the glass under the dispensing tap, making sure that its end-piece is not in contact with the
glass.
• Pull the dispensing tap handle towards you while holding the glass inclined at a slight angle. The
quantity of foam depends on the glass inclination. Set the glass upright as the beer level rises.
• Return the tap handle to its original position when the foam reaches the glass brim. The beer will
stop flowing.
CARE AND MAINTENANCE

Keg Removal and Cleaning the Unit
When the keg is empty, it is advisable to thoroughly clean the Party Pub
before loading another keg.
a) To empty remaining beer from the beer line and remove the keg.
• Open the door and shut the regulator valve (to shut the valve,
turn it counter clockwise).
• Place a container under the dispensing tap and drain by pulling
the handle towards you until nothing flows.
• Disconnect the hoses from the dispensing head.
• Empty the remaining gas using the relief valve supplied
as indicated in the photograph to the right. You will hear
a “hissing” sound that will indicate that all of the
remaining gas is being expelled, continue this step until
you no longer hear the “hissing” sound.
You can select temperature display setting from Fahrenheit to Celsius degree by pushing
appear in blue color in the temperature display window.