American Fibertek RD-20D AFINETY - Manual (Page 8)

8
SETUP
The setup procedures are separated into two classes for clarity. IP & ADMIN menus are
for settings connection parameters for access via web or telnet/RS232. The MONITOR
menu is for viewing text displays of status information and setting user alarm levels and
priorities.
IP CONFIG Menu
IP n.n.n.n – Enter the command IP followed by the IP address to assign to this
Ethernet port in dotted quad format. (Default 192.168.100.10)
NETMASK n.n.n.n - Enter the command NETMASK followed by the Subnet mask
specification in dotted quad format. (Default 255.255.255.0)
GATEWAY n.n.n.n - Enter the command GATEWAY followed by the IP address
of the local area network Internet Gateway in dotted quad format. (Default
0.0.0.0)
NAMESERVER n.n.n.n - Enter the command NAMESERVER followed by the IP
address of the DNS server in dotted quad format. (Default 0.0.0.0) (Optional)
IPLOG – Lists the last 10 unique IP addresses accessing the webserver, most
recent first.
START – Starts the webserver.
STOP – Stops the webserver
SECURE – Sets the webserver to Secure Web Server Mode requiring a
Username and Password to gain access via the web interface.
UNSECURE - Sets the webserver to Un-secure Web Server Mode NOT requiring
a Username and Password to gain access via the web interface.
WEBUSER - Sets the webserver Username to be used in Secure Web Server
Mode
WEBPASS - Sets the webserver Password to be used in Secure Web Server
Mode
ADMIN Menu
Username - Sets the administrative port Username to be used via the Telnet or
RS232 port.
Password - Sets the administrative port Password to be used via the Telnet or
RS232 port
Site ID – Text string posted on the Web Interface identifying the site of the
installation.
Rack ID - Text string posted on the Web Interface identifying the specific rack at
the site of the installation.
TIMEZONE n - Sets the time zone, as an offset in hours from GMT.