Asus K8S-MX - Manual (Page 32)

1-22 Chapter 1: Product introduction
8. Chassis intrusion connector (4-1 pin CHASSIS)
This lead is for a chassis designed with intrusion detection feature. This
requires an external detection mechanism such as a chassis intrusion sensor
or microswitch. When you remove any chassis component, the sensor triggers
and sends a high-level signal to this lead to record a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a
jumper cap. If you wish to use the chassis intrusion detection feature, remove
the jumper cap from the pins.
7. Front panel audio connector (10-1 pin FP_AUDIO)
This is an interface for the front panel cable that allows convenient connection
and control of audio devices.
Be default, the pins labeled LINE OUT_R/BLINE_OUT_R and the pins
LINE OUT_L/BLINE_OUT_L are shorted with jumper caps. Remove the caps
only when you are connecting the front panel audio cable.
K8S-MX
®
BLINE_OUT_L
MIC2 Line out_R Line out_L
BLINE_OUT_R
NC MICPWR
+5V
A
AGND
K8S-MX Front panel audio connector
FP_AUDIO
K8S-MX
®
K8S-MX Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)