Installation instructions, Step 12a (continued) – GE ZIS420NX User Manual
Page 17
STEP 12A (continued)
Custom Handles
,I\RXDUHXVLQJFXVWRPKDQGOHVWKHKDQGOHPXVW
be properly secured to the overlay panel before sliding
the panel into the trim.
7KHFDELQHWPDQXIDFWXUHUZLOOVXSSO\WKHFXVWRP
handle and hardware.
'LVFDUGWKHVXSSOLHGKDQGOH
5HPRYHWKHWULP3HHODZD\DIHZLQFKHV
of the adhesive backing.
IMPORTANT: 7KHWDSHLVYHU\VWLFN\DQGVWURQJ2QFH
it adheres to a surface, it cannot be removed without
damaging both surfaces. Do not install the trim before
the final wood panels are in place. Be sure to align
the trim carefully before removing the paper backing.
Reinstall all original screws.
5HLQVWDOOWKHKDQGOHVLGHWULPXVLQJDOOVXSSOLHG
flat-head screws, plus the 12 flat-head screws
originally installed in the handle trim.
,QVWDOODVXSSOLHGHQGFDSRQWRWKHWRSRIWKHGRRU
using a Phillips head screwdriver and the 2 screws
provided. Hand-tighten the screws into the end caps.
Do not overtighten; damage will occur.
&OHDQWKHDOXPLQXPWULPZLWKUXEELQJDOFRKRO³
do not use alcohols with oil or lanolin that will prevent
adhesion of double-sided tape.
6OLSWKHDOXPLQXPFRYHUWULPEHKLQGWKHWRSHQGFDS
WRFKHFNWKHILW7KHDOXPLQXPFRYHUWULPKDVDUHFHVV
on each end which fits the end cap.
Installation Instructions
Top End Cap
Fits Over the
Aluminum Trim.
Secure Cap with
2 Screws.
End Cap
STEP 12A (continued)
&DUHIXOO\SODFHWKHDOXPLQXPFRYHUWULPLQWRWRS
end cap so that the recess is aligned with the cap.
8VHWKHWRSWRERWWRPJURRYHVDORQJWKHKDQGOHVLGH
to align the cover trim accurately. Pull the tape a few
inches at a time while pressing the trim against
the door. Press and hold approximately 10 seconds
before continuing along the length of the door.
,QVWDOODQRWKHUHQGFDSDWWKHERWWRPRIWKHGRRU
WRVHFXUHWKHFRYHUWULP8VHDVWXEE\3KLOOLSVKHDG
screwdriver and the 2 screws provided.
NOTE: Make sure there are no gaps in the installation.
)ROORZWKHVDPHSURFHGXUHRQWKHRSSRVLWHGRRU
Insert Aluminum
Trim Into End
Cap.
Cover Trim
End Cap