ASKO D3 User Manual

Page 10

Page 10

FITTING THE

FITTING THE D3252XLFI, D3532XLFI AND D3532XLFIWS

D3252XLFI, D3532XLFI AND D3532XLFIWS

CUST

CUSTOM DOOR

OM DOOR

OM DOOR P

PANEL

ANEL

The D3252XLFI, D3532XLFI, and D3532XLFIWS can
only be installed with a fully-integrated custom door
panel that extends from the toe kick to the counter top.
The unit comes with everything needed to make
installing the door panel easy. The door is predrilled for
the panel’s mounting screws.

Width:

23-1/2” (597 mm)

Height:

30 1/8" (765 mm)
(Measured from the top of the panel to the lower edge of
the kitchen cabinet.)

Thickness:

3/4” (19 mm) max

Weight:

Up to 22 lb.

Fit the handle onto the panel according to the manufacturer’s instructions.
(NOTE: A handle should be used rather than a knob, because a knob
does not provide enough grip.)

NOTE:

Before fitting the custom panel, the dishwasher must be installed

underneath the cabinet. After you’ve made the required measurements,
pull the machine out again to install the panel.

NOTE: Specifications subject to change without notice.

PREP

PREPARING

ARING

ARING THE

THE

THE W

WOOD P

OOD P

OOD PANEL FOR MOUNTING

ANEL FOR MOUNTING

ITEMS PR

ITEMS PRO

OVIDED

VIDED

VIDED WITH

WITH

WITH THE

THE

UNIT

♦

Two 3/8” screws

♦

Four 1-3/4” screws

CUST

CUSTOM P

OM P

OM PANEL DIMENSIONS

ANEL DIMENSIONS

Lay the template edge-to-edge with the lower edge of the dishwasher
door or the adjusting frame. The broken line on the template must
pass through the center of the keyholes on the door.

Using a pen or screw, punch holes in the template where the
keyholes are.

Lay the template on the back of the wood panel, edge-to-edge with
the rear of the lower edge and the left edge of the panel.

Mark the location of the hole on the panel.

Turn the template over and lay it on the right side of the wood panel
and mark the location of the second hole.

Screw the short screws into the markings on the wood panel, letting
them project by about 1/16".

30 1/8

765 mm