GE PHS920SFSS - Manual (Page 25)

49-80695-1
25
Lift-Off Oven Door
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-
blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
5. Lift door up and out until both hinge arms are clear of
the slots.
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge
of the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
5. Close the oven door.
Removal position
Hinge lock
Slot
Pull hinge locks down to unlock
Push hinge locks up to lock
Hinge
lock
Hinge
arm
Indentation
Bottom
edge of
slot
Hinge arm
CARE AND CLE
ANING:
Maintenance
Maintenance (Cont.)
Removable Warming Drawer Pan
NOTE: For models with an electric warming drawer
before performing any adjustments, cleaning or service,
disconnect the range electrical power supply at the
household distribution panel by removing the fuse or
switching off the circuit breaker. Make sure the drawer
heating element is cool.
NOTE: Allow warming drawer to cool before removing pan.
NOTE: Wipe spills promptly after each use.
Ŷ 1HYHUSODFHXVHRUVHOIFOHDQWKHGUDZHUSDQLQWKH
upper oven.
Ŷ :DUPLQJGUDZHUKDVDUHPRYDEOHSDQIRUHDV\
cleaning. Clean with hot, soapy water and a sponge
or dish towel. Dry with a clean cloth. Replace the pan
in the warming drawer.