AEG LAVAMAT 86810 - Manual (Page 37)

37
7. Open the porthole and remove the
polystyrene block fitted with the ad-
hesive tape on the door seal.
8. Fill the smaller upper hole and the
two large ones with the correspond-
ing plastic plug caps supplied in the
bag containing the instruction
booklet.
Important!
All the different plug caps are sup-
plied with the appliance in the plas-
tic bag containing the instruction
booklet.
Connect the water inlet hose as described under the paragraph “Water
inlet”.
Where to install
Important! The washing machine must not be operated in a room
where there is a danger of frost. There is a risk of frost damage or ad-
verse effect on the perfomance of the machine. Frost damage is not
covered under the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpeted floors or soft floor
coverings.
• The surface on which the appliance is to be installed must be clean
and dry and free from grease, so that the appliance does not slide.
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.