AEG LAVAMAT 86810 - Manual (Page 19)

19
Starting a programme
1. Check that the water tap is open.
2. Press the START/PAUSE key.
The programme is started or it starts after the time delay set has
elapsed.
3
If after pressing the START/PAUSE key the display shows “Door not
Closed”, the door has not been shut properly. Push the door firmly
closed and press the START/PAUSE key again.
Programme progress
The display indicates the
stage of the programme that
is currently being performed
as well as the time to the
end of the programme.
3
During the wash cycle the
time to the end of the pro-
gramme may change as the
programme adjusts itself to different conditions (e. g., type and quanti-
ty of laundry, out of balance spin detection, special rinses, etc.).
Interrupting a programme/Adding washing
Interrupting a programme
• The programme can be interrupted at any time by pressing
the START/PAUSE key. It is then re-started by pressing the key again.
• To stop the washing machine before the programme has ended, turn
the programme knob to OFF.
Attention! Be careful if there is water in the appliance!
Adding washing
1. Press the START/PAUSE key.
• If “Door locked” and “Pause” are alternately shown in the display, it is
no longer possible to add washing, e. g. when the water level is too
high.
• If “Door openable” and “Pause” are alternately shown in the display, it
is still possible to add washing:
2. Open the door.
3. Add washing and close the door again.
4. Press the START/PAUSE key again. The programme continues.
L I N E N / E A S Y C A R E
12.45
W a s h i n g
14.37
50C 800 aýýýýýaýaýaýaýaýaýaýaýa
TEMP. RPM OPTIONS OK TIME