Nilfisk-ALTO SCRUBTEC 651BCL - Manual (Page 77)

9097058000(2)2009-10 A SCRUBTEC 653B – 653BL – 651BCL – 661BL 15
USER MANUAL ENGLISH
BEFORE MACHINE START-UP
Brush/pad-holder deck or cylindrical brush deck installation/removal
The machine can be equipped with either the brush/pad-holder deck (18a and 18b) or the cylindrical brush deck (18c).
For deck installation/removal see the procedure in Maintenance chapter.
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the
same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
Brush/pad-holder installation/removal
According to the kind of cleaning to be performed, the machine can be equipped either with brushes (A, Fig. 2) or pad-holders 1.
(B) with pads (C) together with the appropriate deck.
Insert the ignition key (80) and turn it to “I”.
2.
If equipped, turn the speed adjuster (84) to idle by turning it counter-clockwise. 3.
Place the brushes (A) or the pad-holders (B) under the appropriate deck (18a) or (18b). 4.
Lower the deck on the brushes/pad-holders by pressing the pedal (11). 5.
Turn the ignition key (80) to “I”. 6.
Press the brush/pad-holder switch (71). 7.
Press one of the switches (83) to engage the brush/pad-holder, then release it. If necessary, repeat the procedure until the 8.
brushes/pad-holders are engaged.
S311334
Figure 2
WARNING!
(Only for SCRUBTEC 653BL, SCRUBTEC 651BCL, SCRUBTEC 661BL): Turn the speed adjuster (84) counter-
clockwise to drive the machine at the minimum speed.
To engage the brush/pad-holder press the switch (83) which turns on the brush/pad-holder motor.
To remove the brushes/pad-holders, the deck must be lifted by pressing the pedal (11), then press the switch (75) and wait for 9.
the brush/pad-holder to fall on the fl oor.
Turn the ignition key (80) to “0”.