Mounting the monitor – HP ZR2330w 23-inch IPS LED Backlit Monitor User Manual
Page 20
Mounting the Monitor
The monitor panel can be attached to a wall, optional swing arm, or other mounting fixture. Mounting
solutions are sold separately.
NOTE:
This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
1.
Remove the monitor panel from the pedestal base. Refer to
CAUTION:
This monitor supports the VESA industry standard 100 mm mounting holes. To
attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long
screws are required. Longer screws must not be used because they may damage the monitor. It
is important to verify that the manufacturer’s mounting solution is compliant with the VESA
standard and is rated to support the weight of the monitor display panel. For best performance, it
is important to use the power and video cables provided with the monitor.
2.
To attach the monitor to an optional swing arm, insert four 10mm screws through the holes on
the swing arm plate and into the mounting holes on the monitor.
Figure 2-14
Mounting the Monitor
To attach the monitor to other optional mounting fixtures, follow the instructions included with the
mounting fixture to ensure that the monitor is safely attached.
3.
Reconnect the cables to the monitor panel.
14
Chapter 2 Setting Up the Monitor