Connecting the cables – HP ZR2330w 23-inch IPS LED Backlit Monitor User Manual

Page 11

Connecting the Cables

Place the monitor in a convenient, well-ventilated location near the computer.

Remove the cable management clip from the pedestal by pulling outward on the two sides of the
clip (1) then lifting the clip off the pedestal (2).

Figure 2-3

Removing the Cable Management Clip

Connect a VGA signal cable, DVI-D signal cable, or DisplayPort signal cable. Refer to

Figure 2-4

Connecting the Cables on page 6

NOTE:

The monitor is capable of supporting either analog or digital input. The video mode is

determined by the video cable used. The monitor will automatically determine which inputs have
valid video signals. The inputs can be selected by pressing the

+/source

button on the front

panel or through the On-Screen Display (OSD) feature by pressing the

button.

●

For analog operation, connect the VGA signal cable to the VGA connector on the rear of
the monitor and the other end to the VGA connector on the computer (cable provided).

●

For DVI digital operation, connect the DVI-D signal cable to the DVI connector on the rear
of the monitor and the other end to the DVI connector on the computer (cable provided).

●

For DisplayPort digital operation, connect the DisplayPort signal cable to the DisplayPort
connector on the rear of the monitor and the other end to the DisplayPort connector on the
computer (cable provided).

Connect one end of the provided USB cable to the USB hub connector on the rear panel of the
computer, and the other end to the upstream USB connector on the monitor.

Connecting the Cables