beautypg.com

Troubleshooting – Ariens Sno-Tek 03883300A User Manual

Page 28

background image

GB - 28

TROUBLESHOOTING

PROBLEM

PROBABLE CAUSE

CORRECTION

Engine will
not
crank/start.

1. Fuel tank is empty.
2. Fuel shut-off valve

closed.

3. Build up of dirt and

residue around
governor/carburetor.

4. Key switch not in run

position.

5. Engine start switch turned

off.

1. Fill fuel tank.
2. Open fuel shut-off valve.

3. Clean area around

governor/carburetor.

4. Put Key switch into run

position.

5. Turn switch on. See Starting

and Shut Off on page 15.

Engine stops.

1. Out of fuel.
2. Fuel shut-off valve

closed.

3. Mechanical jam in auger

or impeller.

4. Contaminated fuel supply.
5. Faulty spark plug.

1. Fill fuel tank.
2. Open fuel shut-off valve.

3. Turn off engine, remove key,

and wait for all moving parts to
stop. Check for and remove
obstruction and repair before
restart.

4. Replace with clean fuel.
5. Replace or clean spark plug.

Engine
problems.

1. See Engine Manual.

Does not
operate in
Forward /
Reverse.

1. Friction disc not adjusted

properly.

2. Traction belt not

functioning.

3. Speed selector not

adjusted properly.

1. Repair or replace friction disc

(see Friction Disc Replacement
on page 26).

2. Repair or replace traction drive

belt (see Traction Drive Belt
Replacement
on page 22).

3. Adjust speed selector (see

Speed Selector Adjustment on
page 20).

Small rubber
beads collect
in frame

1. Friction disc wear.

1. Normal friction disc wear.

Chunks or large pieces of
rubber mean friction disc
should be checked and
replaced as necessary.

Unit throws
snow poorly
or does not
throw snow.

1. Shear bolts broken.

2. Attachment clutch/brake

not adjusted properly.

3. Auger is frozen in place.

4. Ice or debris is

obstructing auger.

5. Attachment drive belt

slipping, worn or
damaged.

1. Replace shear bolts (see Shear

Bolts on page 19).

2. Adjust attachment clutch/brake

(see Attachment Clutch/Brake
Adjustment
on page 23).

3. Move unit to a warm place to

thaw.

4. With the engine off and auger

disengaged, check for
obstructions and remove.

5. Adjust or replace attachment

drive belt (see Attachment
Clutch/Brake Adjustment
on
page 23).

This manual is related to the following products: