HP Netserver L Server series - Manual (Page 20)

Chapter 3 Installing UPS Software
14
•
(Optional) HP NetServer Assistant is installed on your server and central
management console, if you are using it to manage the server
To Install the UPS Software on the HP NetServer
NOTE You must have administrator capabilities to install this
software.
To install the UPS Software on the HP NetServer to which the UPS is connected,
perform the following steps:
1. Insert the HP NetServer Navigator CD-ROM into the CD-ROM drive.
2. In the Windows NT Program Manager, select Run from the File drop-down
menu.
3. At the Command Line prompt, type the following:
{drive}:\PWA\WINNT\DISK1\SETUP.EXE
where {drive} is the letter of the CD-ROM drive.
4. Follow the instructions on the screen.
◊ You will be prompted to identify an installation path for the software.
◊ In the Installation Options window, select PowerWise Assistant.
◊ You will need to identify the serial port on the server to which the HP
PowerWise UPS is connected.
To Install the UPS User Interface on a Local Client PC
Optionally, you can install the HP PowerWise Assistant user interface on a local
client PC that you will be using to manage the HP PowerWise UPS. Do the
following steps:
1. If the server’s CD-ROM drive is accessible from the client, keep the CD-
ROM at its present location. Otherwise, put the HP NetServer Navigator
CD-ROM in the CD-ROM drive of the client. If you do not have access to
a CD-ROM drive at the client, run the installation procedure to create
installation diskettes.
2. In the Windows NT Program Manager, select Run from the File drop-down
menu.
3. At the Command Line prompt, type the following: