Asus E2898 - Manual (Page 53)

ASUS Striker Extreme 2-27
3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5,
SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, RAID 5, or JBOD configuration with the onboard NVIDIA ®
MediaShield™ RAID controller.
The RAID function of these connectors is set to [Disabled] by default. If you
intend to create a Serial ATA RAID set using these connectors, enable the RAID
Enabled item under the Serial ATA Configuration sub-menu in the BIOS. See
section “4.5.3 Onboard Device Configuration” for details.
These connectors support Native Command Queuing (NCQ), Power
Management (PM) Implementation Algorithm, Hot Swap and smart setup.
STRIKER EXTREME
®
STRIKER EXTREME IDE connector
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
STRIKER EXTREME
®
STRIKER EXTREME SATA connectors
SATA1
GND RSA
TA
_TXP1
RSA
TA
_TXN1
GND RSA
TA
_RXP1
RSA
TA
_RXN1
GND
SATA2
GND RSA
TA
_TXP2
RSA
TA
_TXN2
GND RSA
TA
_RXP2
RSA
TA
_RXN2
GND
SATA3
GND RSA
TA
_TXP3
RSA
TA
_TXN3
GND RSA
TA
_RXP3
RSA
TA
_RXN3
GND
SATA4
GND RSA
TA
_TXP4
RSA
TA
_TXN4
GND RSA
TA
_RXP4
RSA
TA
_RXN4
GND
SATA5
GND RSA
TA
_TXP5
RSA
TA
_TXN5
GND RSA
TA
_RXP5
RSA
TA
_RXN5
GND
SATA6
GND RSA
TA
_TXP6
RSA
TA
_TXN6
GND RSA
TA
_RXP6
RSA
TA
_RXN6
GND