HP L1750 17-inch LCD Monitor - Manual (Page 32)

Icon Main Menu Submenu Description
Sleep Timer Provides the timer adjustment menu options:
● Set Current Time—sets the current time in hours
and minutes
● Set Sleep Time—sets the time you want to place
the monitor in sleep mode
● Set on Time—sets the time you want the monitor
to wake up from sleep mode
● Timer—sets the Sleep Timer feature On or Off.
The default setting is Off.
● Sleep Now—immediately sets the monitor to
enter sleep mode
Video Input
Control (select
models) Selects the video input signal. DVI is the factory
default.
Switch Video Input Analog — VGA — Selects VGA input
Digital — DVI — Selects DVI input. This input accepts
either analog or digital signals.
Disable/Enable Auto-
Switching Enables or disables the system's automatic video
signal input-switching feature. The factory default is
enabled.
Default Video Input Selects the default or primary video input signal when
the monitor is connected to two active and valid video
sources. The monitor will automatically determine the
video format. The default input selection is DVI.
Analog — VGA — Selects VGA input.
Digital — DVI — Selects DVI input.
Information Selects and displays important information about the
monitor.
Current Settings Provides the current input video mode.
Recommended
Settings Provides the recommended resolution mode and
refresh rate for the monitor.
Serial Number Reports the serial number of the monitor. The serial
number is needed if contacting HP technical support.
Version Reports the firmware version of the monitor.
Backlight Hours Reports the total hours of backlight operation.
Service Support: http://
www.hp.com/support
Factory Reset Returns all OSD menu settings and DDC/CI controls
to the factory default settings, except the Language.
Exit Exits the OSD menu screen.
Table 4-2 OSD Menu (continued)
26 Chapter 4 Operating the Monitor