Configuring secure file copy, Setting the boot prom password – HP StorageWorks 2.128 SAN Director Switch User Manual
Page 67
Fabric OS 5.x administrator guide
67
Sample view of the SNMP MIB trap setup:
Configuring secure file copy
Use the
configure
command to specify that secure file copy (scp) be used for configuration uploads
and downloads. For example:
Setting the boot PROM password
The boot PROM password provides an additional layer of security by protecting the boot PROM from
unauthorized use. Setting a recovery string for the boot PROM password enables you to recover a lost
boot PROM password by contacting your switch service provider. Without the recovery string, a lost boot
PROM password cannot be recovered.
Set the boot PROM password and the recovery string on all switches. If your site procedures dictate that
you set the boot PROM password without the recovery string, see ”
To set the boot PROM password with a recovery string, see the section that applies to your switch model.
NOTE:
Setting the boot PROM password requires accessing the boot prompt, which stops traffic flow
through the switch until the switch is rebooted. Perform this procedure during planned down time.
switch:admin> snmpmibcapshow
FA-MIB: YES
FICON-MIB: YES
HA-MIB: YES
SW-TRAP: YES
swFCPortScn: YES
swEventTrap: YES
swFabricWatchTrap: YES
swTrackChangesTrap: YES
FA-TRAP: YES
SW-EXTTRAP: YES
HA-TRAP: YES
fruStatusChanged: YES
cpStatusChanged: YES
fruHistoryTrap: YES
switch:admin> configure
Not all options will be available on an enabled switch.
To disable the switch, use the “switchDisable” command.
Configure...
System services (yes, y, no, n): [no] n
ssl attributes (yes, y, no, n): [no] n
http attributes (yes, y, no, n): [no] n
snmp attributes (yes, y, no, n): [no] n
rpcd attributes (yes, y, no, n): [no] n
cfgload attributes (yes, y, no, n): [no] y
Enforce secure config Upload/Download (yes, y, no, n): [no] y
switch:admin>