Avanti W892F User Manual

Page 13

6. Do not pour undiluted liquid bleach directly into the load or drum.

OPERATING INSTRUCTIONS

PRESS DOWN POWER BUTTON.
Press once to turn the washing machine ON, press again to turn the washing machine OFF.
After the washing program has been finished, the power will automatically turn off.

NOTE: If the power is left ON for longer than 10 minutes without any buttons being touched, the
power will turn off automatically.

PRESS DOWN FABRICS BUTTON.
Choose the right available program according to wash load as following:
COTTON PERM PRESS DELICATES KNIT/WOOL
The default Fabrics is Perm Press.
For different FABRICS program, there are different default water temperature and cycle process as
following:

FABRICS

WATER

TEMPERATURE

CYCLE

COTTON

HOT/COLD

WASH+RINSE+SPIN

PERM PRESS

WARM/COLD

WASH+RINSE+SPIN

DELICATES

WARM/COLD

WASH+RINSE+SPIN

KNIT/WOOL

COLD/COLD

WASH+RINSE+SPIN

PRESS DOWN CYCLE BUTTON.
Press the button repeatedly to select the available wash process as following:
WASH+RINSE+SPIN PREWASH+WASH +RINSE+SPIN SPIN RINSE+SPIN

WASH+RINSE

The default cycle is WASH+RINSE+SPIN.

NOTE: Prewash is only available when washing COTTON and PERM PRESS.

PRESS DOWN WASH/RINSE WATER TEMPERATURE BUTTON.
Press down the water temperature selection button, you can choose to inlet cold water or hot water for
the wash and rinse process as following:
HOT/COLD WARM/WARM WARM/COLD COLD/COLD
The default water temperature is WARM/COLD.

NOTE: HOT/COLD is only available when washing COTTON and PERM PRESS.

IMPORTANT: A single cold hose system does not allow the washing machine to automatically
regulate incoming water temperatures to match those listed on the control panel. Only COLD/COLD
can be available.

PRESS DOWN EXTRA RINSE SELECTION BUTTON.
Press down the button when Extra Rinse is needed.
When you choose Extra Rinse, you will see the indicator lights up on the control panel.

NOTE: Extra Rinse is not available for Spin only process.

PRESS DOWN DELAY START SELECT BUTTON.
Press this button repeatedly to choose the delayed start time (From 1 to 24 hours in one hour
increment).
After the Delay Start has been chosen, the Delay Start indicator flashes and the LED displays the
remaining delay time.
To cancel the Delay Start, press down the power button or press down the Delay Start repeatedly to