Avanti W892F - Manual (Page 10)

10
? POSITIONING THE DRAIN HOSE
The end of the drain hose may be positioned as following two ways:
?
Over the edge of a sink
The drain hose must be placed at a height of between 0.6 ~ 0.9 m. To keep the drain hose spout
bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the
faucet with a piece of string to prevent the drain hose from
moving.
?
In a drain pipe
We recommend you use a vertical pipe with height between 0.6 ~
0.9 m. The inside diameter of the drain pipe must be larger than
the outside diameter of the drain hose.
NOTE: The outlet of the drain hose must be in the height of 0.6 ~ 0.9
m above floor level, otherwise, the washing machine cannot work
normally.
? ELECTRICAL CONNECTIO N
This portable washer should be properly grounded for your safety.
The power cord of this appliance is equipped with a three-prong plug
which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong
from the power cord supplied.
This appliance requires a standard 110-120 Volts~A.C./60Hz electrical
outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed
or dangling to prevent accidental injury.
Never unplug the appliance by pulling the power cord. Always grip the
plug firmly and pull straight out from the receptacle.
Do not use an extension cord with this appliance. If the power cord is
too short, have a qualified el ectrician or service technician install an
outlet near the appliance.
?
Warning
?
Improper use of th e grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Avanti Products service center.
STANDARD 120
VOLTS, 60 HERTZ,
3-WIRE SOCKET
GROUND
120 12
V.A.C.
± 0
V.A.C.
115 12
V.A.C.
±
L1 NEUTRAL
SIDE
ROUND
GROUNDING
PRONG