HP StorageWorks 2.64 Director Switch - Manual (Page 19)

Introduction
19 Embedded Web Server User Guide
Using EWS to Perform Tasks
Users can perform the following tasks using EWS:
■ Display the properties and operational status of the product, FRUs, and Fibre
Channel ports; display product operating parameters; and display fabric
parameters.
■ Configure the director or edge switch, including:
— Fibre Channel port parameters, port types, and data transmission speeds.
— Product identification, date and time, operating domain parameters, fabric
parameters, and network addresses.
— Parameters for product management through Simple Network
Management Protocol (SNMP), the Command Line Interface (CLI), the
Open System Management Server (OSMS) feature, or the Fibre
Connection (FICON) Management Server (FMS) feature.
Note: The Edge Switch 2/24 does not support out-of-band management through
FMS. However, the Edge Switch 2/24 does support transmission of FICON frames.
— Zones and zone sets.
— User rights (administrator and operator).
— Port binding, switch binding, fabric binding, and Enterprise Fabric
Management.er rights (administrator and operator).
■ Monitor ports and port statistics and display the event log and node list.
■ Perform product operations and maintenance tasks, including:
— Enable unit beaconing, turn off the system error light, set the product
online or offline, and perform a configuration reset.
— Enable port beaconing, perform port diagnostics, and reset ports.
— Retrieve dump files and retrieve product information files.
— Install optional feature keys.
— Configure product Internet Protocol (IP) addresses, names, and SNMP
settings.
— Install new versions of product firmware.
— Manage user access to features.