Enww status-alert messages 85 – HP LaserJet P2035 User Manual
Page 95
Alert message
Description
Recommended action
Manual feed
The product is set for manual feed mode.
Load the correct paper into the tray, and then
press the
Go
button to clear the message.
Non-HP black cartridge
A new, non-HP supply has been installed.
This message appears until an HP supply is
installed or you press the
Go
button.
If you believe you purchased an HP supply,
go to
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
To continue printing, press the
Go
button.
Not Connected
The product software cannot communicate
with the product.
1.
Make sure the product is turned on.
2.
Make sure the USB cable is connected
securely to the product and the
computer.
Order black cartridge
The identified print cartridge is nearing the
end of its useful life.
Order a new print cartridge. You can continue
printing with the current print cartridge until
redistributing the toner no longer yields
acceptable print quality.
Page too complex
The product cannot process the page.
Press the
Go
button to continue printing the
job, but output might be affected.
Printer mispick
The print engine has failed to pick up a piece
of paper.
Reload the paper in the input tray and press
the
Go
button to continue the job.
If the message persists, contact HP support.
See
.
Printing
The product is printing a document.
Wait for printing to finish.
ENWW
Status-alert messages
85