HP Deskjet 6127 Color Inkjet Printer - Manual (Page 15)

connecting the printer to an ethernet network
connecting the printer to an ethernet network
Follow these steps to connect the printer to an ethernet network.
1. If necessary, set up the printer hardware.
For printer hardware setup instructions, see the setup poster that came with the printer.
2. Verify that the printer is powered on.
3. Connect the ethernet cable to an available port on the ethernet hub or router .
4. Connect the ethernet cable to the ethernet port on the back of the printer.
To prevent damaging the printer, do not use a phone
cord to connect the printer to an ethernet network,
and do not connect the printer to a phone jack.
5. Do one of the following:
if the link light is... then...
Install the printer software on the network computers .
file:///C|/enu/ug_ethernet_install_most_fs.html (1 of 2) [12/17/2002 1:00:33 PM]