HP StorageWorks 2.32 Edge Switch - Manual (Page 178)

SANtegrity Security Center 178
Using the Users tab
The Security Administrator uses the Users tab to set up role-based user access to the selected switch
through other management interfaces, such as HAFM Basic or Telnet.
Figure 108 Security Center Users tab
If the Enable EWS (HAFM Basic) or Enable Telnet check box is not selected, then no user can log in
to the switch through this interface. When the interfaces are enabled, HAFM Basic and Telnet can
be set to authenticate to a local database on the switch, a RADIUS server, or a local database and
then a RADIUS server. If the SSH check box is selected then all management data between the
workstation and the switch through Telnet is encrypted using the SSH protocol.
If Radius Only is selected from the list, your HAFM appliance checks the RADIUS information to
determine if a RADIUS server has been specified. If not, the application prevents the user from
selecting this option and a message is displayed.
If the RADIUS server is already set, the Security Administrator is alerted that the user information on
the RADIUS server must be entered manually. The HAFM appliance cannot populate that
information automatically.
Assigning users to a switch
For the user role, there are two options available from a list, Administrator and Operator. The ID of
the user is Administrator and the password is password. The third and fourth column indicate
whether a user has access to the switch through the HAFM Basic or Telnet interface, or through
both of them.