Audiovox PRO-9671FT User Manual

Page 15

ALARM SELECTABLE FEATURES

NOTE: The Alarm Selectable Features and Remote Start Selectable Features programming steps following are based

on transmitter button 1 being programmed for channel 1 and transmitter button 2 being programmed for channel 2.
RF Programmable Features:
Feature Selection

1 Chirp

2 Chirp

Default

First

1 Second Door Locks

3.5 Second Door Lock

1 Second

Second

Auto Lock On

Auto Lock Off

Third

Auto Unlock On

Auto Unlock Off

Fourth

Passive Door Locks

Active Door Locks

Fifth

Passive Arming

Active Arming

Passive Arming

To Program The Alarm's Selectable Features:

LED Flash Pattern

1 Flash Pause etc.

2 Flash Pause etc.

3 Flash Pause etc.

4 Flash Pause etc.

5 Flash Pause etc.

First

Second

Third

Fourth

Fifth

Action
Turn the ignition switch on
Flip the valet/program switch on then off 3 times
Within 3 seconds, turn the ignition switch off
and then on.
Press transmitter button 1 to change.
Or
Flip valet/program switch on then off
Press transmitter button 1 to change.
Or
Flip valet/program switch on then off
Press transmitter button 1 to change.
Or
Flip valet/program switch on then off
Press transmitter button 1 to change.
Or
Flip valet/program switch on then off
Press transmitter button 1 to change.
Or
Flip valet/program switch on then off
Or
Turn ignition switch off.

System Response
No Response
1 Chirp-LED 1 Flash
Short Chirp, then Long Chirp

1 Chirp = 1 second Locks
2 Chirps = 3.5 second Locks
2 Chirps = auto locks off
1 Chirp = auto locks on

2 Chirps = auto unlock off
1 Chirp = auto unlock on

2 Chirps = active locks
1 Chirp = passive locks

1 Chirp = passive arming
2 Chirps = active arming

Exit Program Mode

NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between steps, or
the programming mode will be terminated.

TIMED START PROGRAM:

The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature is useful in
extremely cold climates where starting the engine is the only means to keep the battery charged and fluids
warm. The operator has the option to have the unit start every 2 or 4 hours for a maximum of 48 hours.
Factory pre-set is to start at 4 hour intervals. To select 2 or 4 hour automatic start timer:
1. Start with the Enable switch (Red Handle) in the "On" Position.
2. Turn the ignition on then off.
3. Within 10 seconds of the key turning off, cycle the enable switch Off, On, Off, On ( 2 times) to select a 2 hour
timed start interval. Cycle the enable switch Off, On, Off, On, Off, On, Off, On (4 times) to select a 4 hour timed start
interval. The lights will flash and the siren will chirp 2X or 4X dependant upon 2 or 4 hour interval setting.
NOTE: Once selected, 2 or 4, this timer interval will remain in memory until it is manually changed. To change, the
above sequence will have to be followed.

TIMED START OPERATION:

To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF command to start 2
times. (Press button two 4 times). The lights will flash and the siren will chirp 4 times. Indicating timed interval
mode has been initiated. The vehicle will automatically start every 2 or 4 hours as programmed. To cancel
the timed start mode start the vehicle either by RF or by the ignition key.