Ultra Start 45xx Series - Manual (Page 14)

Page 14
ATTENTION: TO AVOID SERIOUS INJURY, this remote start system must be
set into Service Mode before any under hood servicing is started. Service
Mode will prevent the vehicle from starting while the vehicle is being
serviced. It is the sole responsibility of the vehicle’s owner to place the
system into Service Mode. The manufacture accepts no responsibility for
accidental starting of the vehicle while the vehicle is being serviced.
Emergency Service Mode - (Valet Mode)
This feature will disable the system except for lock, unlock and trunk functions.
This mode is used if a remote is misplaced, damaged or if the system malfunctions.
If the system was installed with a starter disable this feature will disable the starter
disable relay and allow the vehicle to start.
Activate/ Deactivate Service Mode (Valet Mode)
To enter Service Mode turn the ignition key to the “On” position then press and hold
the Program Button located on the antenna for 5 seconds. The system will chirp the
siren 5 times as confirmation. To Deactivate Service Mode, turn the ignition key
“On” and hold the Program Button Until The siren Chirps 2 times.
While the system is in Service Mode the remote starter and alarm functions will be
disabled and the LEDs on the antenna will come “On” steady. As confirmation of
Service Mode. The door lock, unlock and the trunk release will still be operational.
System Service Mode(Valet) - By Remote
ACTIVATE/DEACTIVATE Service Mode (User Programmable Feature)
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the ? starts flashing on the screen.
3 - Press button #3 to activate or #2 to deactivate Service Mode.
4 - Press button #4 to exit User Program Mode.
The System is Now in Service Mode.
5 - The siren will chirp once and the LEDs on the antenna will come on solid.
Service Mode
OWNER’S GUIDE
2way REMOTE STARTER/ ALARM